My blog and 3D prints
My blog and 3D prints
Solutionism... trying to solve everything by creating more problems :( This story starts with me trying to once and for all solve my under voltage alerts on my raspberry pi. As you know from previous posts, my Pi is leeching power from my Ender's P
Wooooot! Calibration time come on! Now that my Virtual server woes have been dealt with, we're printing again! This time we're going to tune our startup sequence. Reduce our prep time and minimize our time to print! But before we dive into that, we
Back again with another tech post! Don't worry, this isn't going to be another crazed rant! This has been something in the works for a bit that I had to get out. A long time ago, I made this virtual server from some old hardware lying around to run
We're back!! This time we're fuuuuuuming! WHEN IT COMES TO OPEN SOURCE SOFTWARE THERE ARE PRINCIP.... *deep sigh*. OK, before I go into full blown rant mode, lets take a step back. Unlike the last post, this won't about 3D printing or upgrades, just
Yeah, yeah, yeah... I'm going to talk about Crypto. I'm sure you've come across someone who has talked your ear off about how amazing crypto is. How its the next generation of money, its the ultimate middle finger to the banks, and how it grants
Hello again! Remember a few posts ago when I said I would get back into printing after I get things situated? Welp, now that I finished my Halloween post, I think its time to debrief on how we got there. Lots of lessons learned and silly mistakes to
Finally! Getting back into technical things again! Unless you think Fold@home is a form of yoga you do at home with a class over a zoom call. Well, depending who you ask, its much cooler than that! Don't worry, we'll get back into 3D printing soon e
Here we are back at again, Round 3!! Last time we left off with using OpenHAB to automate the printing lights on a job start and stop. Now, we take things one step further, by automating more steps when the job stops and me just overall being lazy
Welcome back to the automation trilogy! Last time we talked about a scripty way to get around keeping DNS up to date without needing a static IP. This time we talk about a recent limitation to IF This Then That (IFTTT), an IoT service that interacts
Haza! I managed to get this post in much sooner than I thought! Last time we talked about getting the virtual environment and server setup. This time, we start a 3 part trilogy of how we are going to start using automation again! This time, we start
by 
